Framed Bookcase Assembly Instructions
Step 1
Screw the moulding fastening blocks on the top and bottom
shelf. Install so that the front of the connector is flush with
the front edge of the shelf as shown in the inset photo.
Rounded corners face back. On the top shelf the brackets
are installed on the side with the groove on the back edge.
On the bottom shelf they are installed on the other side
without the groove.
Step 2
Screw the moulding fastening blocks along the front edge of
the bookcase sides. The number of brackets will vary
depending upon the height of your case. Near both the top
and bottom ends of the bookcase sides you will notice a
series of holes bored front to back. Insert wooden dowel
pins in the larger holes. Screw connector bolts into the
smaller holes. Do not overtighten the bolts. Once they are
flush stop.
Step 3
Lay the LEFT bookcase side on a flat surface and install
the top shelf. Line up the holes on the end of the shelf with
the cam bolts on the bookcase side and press downward.
Make certain the groove on the top shelf matches up with
the groove on the bookcase side.
Step 4
Insert the cam washers into the holes with
the cam bolts. The arrow on the washer
points towards the bookcase side at about
the 6 o’clock position. To tighten, turn
clockwise to abou the 2 o’clock position.
Repeat steps 3 and 4 for the bottom shelf.
Woodland Mills
4685 Shaffers Church Road--Glenville, PA 17329
Phone (717) 227-0050 Fax (717) 227-0017
Visit our online store at
www.TheWoodlandMills.com
