Bushlander
™
Operator’s Manual
DRILLING LOCK-DOWN HOLES FOR STANDARD TRAILER
**Do not drill the holes below for the lock-down brackets if a Bushlander
TM
XL trailer
extension was purchased. Follow the directions in the
Place the sawhead on the trailer ensuring it rolls freely along the rails. Measure 61-
¼
in [155.5
cm] from the rear edge of the track rail—
not
the carriage stop—to the rear post of the sawhead
and drill four (4) holes in the track rails using the provided
⅜
in drill bit. Insert a locking pin into
each hole as they are drilled. Secure each locking pin with a linch pin.
BHLR-MY2020-EN: Rev B
Page
of
25
56
20-Aug-2020
61-
¼
in [155.5 cm]
Summary of Contents for BUSHLANDER
