woodize.com
Explanations of the parameter settings menu:
30 - Global brightness of all the LED lights during "Night mode"
31 - In dark environment the maximum brightness of the 'breath e
ff
ect' might be too much. This
parameter allows to reduce the brightness to half. Set to “1” for reduce overall LED brightness
during 'breath' e
ff
ect.
This parameter applies for the 'breath" e
ff
ect ONLY!
32 - Enable "breath" e
ff
ect on all the LED lights. All lights are pulsing from low brightness to
higher.
This feature overrides all color settings!
33 - The GPS synchronization is ON or OFF. Optional GPS unit needed to enable this function.
34 - Depending from your timezone, set the o
ff
set hours from the GMT. Plus or minus precursor
set by this parameter! No Daylight Saving Time (DST) mode. The time need to be adjusted
manually twice a year in DST zone countries.
35 - Depending from your timezone, set the o
ff
set minutes (if apply) from GMT.
36 - Hour/Minutes o
ff
set pre or - from GMT. “0” is, to east of UK (Europe and Asia), “1” is to
west from UK, all USA and America
37 - If your clock is running faster or slower, you can accurately set the clock without any GPS
unit. Study your clock behaviour, make notes for a few days before set anything. Press ADJUST
button to run the clock faster, press ALARM button to run slower.
Each incremental adds or subtracts 0.18 sec per day. Default middle value is 128. Range 0-255.
38 - Restore default settings! At parameter 38 press the ADJUST button for 1 beep to Restore
Default Settings, then press and hold SET button for 3 beeps to exit the setup menu to
activate the reset!!