background image

3

Attach the Router Block 

(1430B or 1430B1) 

to the Vertical

Support assembly using four 1-1/8" barrel nuts 

(5791B)

and four 1/4-20

x 1" screws 

(MF015)

.  Lay the Router Block on its side.  Insert the bar-

rel nuts in the locations shown on the Router Block approximately 7/16"
in to the block.  Make sure the slot in the barrel nut is in line with the
mating cross hole in the Router Block.  

See fig. 4.

Insert a 1/4-20 x 1" screw through the hole in the Vertical Support,

continuing  through the countersunk hole in the Slide and into the Router
Block until it contacts the barrel nut.  Loosely tighten the screw in the
barrel nut.  Repeat this procedure with the other three holes until the
Router Block is loosely attached.  Next lightly tighten the four screws.
Now tighten the four screws fully.  

With the assembly upright, push down on the Router Block until it

slides all the way down to the bottom of it's travel on the Vertical
Supports.  

See fig. 5.

Step 3:

Insert the Lift Nut 

(1430F)

, large threaded hole first, into the

rectangular opening in the Router Block.  

See fig. 6.

Install a 1/4" lock washer 

(WL001) 

and a 1/4" washer 

(WB002) 

on

to the 1/4-20 x 1-1/4" screw 

(MT030)

.  Install the screw through the hole

in the Router Block where indicated and loosely tighten it in the Lift
Nut.  

See fig. 5 & 7.

Install the Adjuster Assembly 

(1430X)

in the Lift Nut.  From the

router plate side of the Router Block, insert the bolt into the Router
Block until it contacts the Lift Nut.  Screw the bolt into the Lift Nut until
the mounting plate of the Adjuster Assembly is slightly above the edges
of the Vertical Supports.  

See fig. 8.

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8

Install Router Block

Handle in Router Block

Attach Router Block

to Slides

5791B

Push Router Block to

bottom of travel

Install Lift Nut

Fasten Lift Nut to Router Block

Mounting Plate of

Adjuster Assembly

Vertical Supports

Router Plate side

of Router Block

Screw Adjuster

Assembly in Router
Block/Lift Nut until

the mounting plate is

slightly above the

Vertical Supports.

Reviews: