Woodbridge WK090802, Installation And Care Manual

Page: 4 / 5

R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
R
WOODBRIDGE WOODBRIDGE
WOODBRIDGE WOODBRIDGE
www.woodbridgebath.com
4
R
WOODBRIDGE
INSTALLATION PROCEDURES
KITCHEN FAUCET
1
2A 2B
Warning!!!
Do not over-tighten nut during installation.
Over-tighten may crack the valve and cause severe leak.
2
3
If necessary, tighten screws using a adjustable
wrench until the faucet is firmly connected to the
sink.
4
install brass adapter to the hose inlet from below, Connect
hot and cold water supply lines to the Water Supply Valves.
Rubber Washer
Metal Washer
Locknut
You should clean all the dirts from valve outlets.
Turning off the water supply valves.This is usually
found near the water meter.If you are replacing
an existing faucet, remove the faucet from the
sink and clean the sink surface thoroughly.
Installation without deck plate, make sure the O-Ring is placed
into the bottom of base ring, install faucet through hole on sink.
From underneath of the sink, insert rubber washer, metal
washer and lock nut onto screwed pipe. Position faucet on
sink properly and hand tighten locknut.
Installation with deck Plate, apply a bead of plumber’s putty
between faucet and sink, place deck plate over the three holes
on sink, tighten with wing nuts from underneath sink.
Make sure the O-Ring is placed onto the bottom of base ring,
insert faucet through deck plate, from underneath of the sink,
insert rubber washer, metal washer and lock nut onto screwed
pipe. Position faucet on sink properly and hand tighten locknut