3
C. Clearance Requirements:
Check the rough-in and room dimensions to provideadequate space for the bath unit.
SITE REQUIREMENTS
A. Plumbing Preparation
Position the plumbing according to rough-in dimensions.
Cap the supplies and check for leaks.
BEFORE INSTALLING UNIT
CAUTION:
Ensure a watertight seal on the bath drain connections.
A. Install the faucet valving and shower head tee.Whendrilling bathtub for faucet,
ensure sufficientclearance. Open the hot and cold water valves and check the
supply connections for leaks.
B. Run water into the bath and check the drainconnections for leaks.
C. Fill the bathtub up to the overflow level and checkoverflow unit for leaks.
INSTALL BATHTUB
1) Your new bathtub beenmanufactured to the highest possible
standards, it has been factory tested and approved.
2)
When removing bathtub from protective carton. DO NOT LIFT BATHTUB BY PIPE WORK.
Inspect for any possible damage that may have occurred in transit.
IMPORTANT:
Bathtub must be installed level on all top edges.
3) Connect Power Supply:
Connect power supply to control unit. The electrical connections must comply with local
authority regulations and must be done by an authorized electrician.
DUAL SYSTEM 15 AMPS Supply
4) Fill bathtub with water to approximately 40 mm above the jets and trial run pump for 10-15
minutes. Check all the fittings for leaks and test the control functions. Switch off the spa
pump and leave the unit filled with water (pump is not running) for at least another two
minutes. Check the pump and pipes union connections for leaks. Hand tighten union
connections if required.
IMPORTANT:
Your bathtub has been factory tested and approved. It is the responsibility of
the installer to test run the bathtub, check all the fittings for leaks and test the control functions.
NON OBSERVANCE WILL INVALIDATE FACTORY WARRANTY.
5) Bathtub Rim Support. Drop-In Models:
CAUTION:
Risk of product damage. Do not support the weight of the bath by the rim.
