Wrought Iron Spring Rocker Dining Chair
Item #W22170
Assembly Instructions
Diagram 1
Diagram 2
**TO AVOID POTENTIAL SCRATCHING TO PARTS BY ROUGH GROUND SURFACE, COVER GROUND
WITH SOFT SMOOTH PROTECTIVE MATERIAL ON WHICH TO PLACE PARTS DURING ASSEMBLY. **
Step 1: Remove protective wrapping and lay all parts on floor. Identify all parts packed in
carton against the parts list.
Step 2: The threaded ends of the Base's (B) two coiled springs need to be inserted through
the double loop openings on the bottom sides of the Seat Bucket (A) as shown in Diagram
1. To make this easier to do, lay Seat Bucket (A) upside down on surface first. Then take
Base (B) and maneuver it to insert the threaded ends of the coiled spring through the
loops on seat.
Step 3: Secure attachment with Hex Nut (C) , Spring Washer (D), and Washer (E) to end
of threaded spring as shown in Diagram 2. Use Hex Wrench (G) to tighten the nuts.
Step 4: Make sure all bolts are aligned properly and securely tightened. Then place Nut
Covers(F) over Hex Nuts.
NOTE: IT IS USER'S RESPONSIBILITY TO MAKE SURE ALL PARTS ARE ASSEMBLED AND
TIGHTENED PROPERLY AND SECURELY.
1 of 2
