23
An ongoing program of product improvement may require us to change
specifications without notice.
MH-W-IR
Revised November 2009
Wood Stone Corporation
1801 W. Bakerview Rd.
Bellingham, WA 98226 USA
Toll Free (800) 578-6836
Tel (360) 650-1111
Fax (360) 734-0223
or visit
www.woodstonehome.com
Mountain Series Installation and Operation Manual
daiLY operation
For additional operational and cooking information please visit
www.woodstonehome.com
or call Wood Stone. The
door(s) are used for nighttime heat retention. Do not operate the appliance with doors in place.
Night Doors
The floor temperature is continuously displayed by the controller in the window labeled "hearth temperature". This
reading is being taken by a thermocouple about an inch below the floor surface, so the actual surface temperature may
be somewhat different, and is best measured using a non-contact (IR) thermometer.
NOTE:
Small "crazing" cracks will occur with normal heating and cooling. They will not effect the performance or durability
of the appliance. If cracks of 1/8" or more develop, contact Wood Stone for evaluation.
The W-IR model is primarily a wood burning appliance with an infrared heater mounted underneath the floor to assist in
speeding heat-up and to assist in managing hearth temperature. After the First Day heat-up, raise the infrared Set point
to desired hearth temperature. If the goal is to cook between 500-530 degrees F, the Set point should be 500 degrees
F. The wood fire is responsible for 75-80% of the energy that the appliance requires to cook properly.
WOOd / GAS ASSIST
HOW TO REAd HEARTH TEMPERATURE
AdJUSTING THE HEARTH SET-POINT
To adjust the thermostatic hearth temperature setting, simply press the arrow button corresponding to the direction in
which you would like the setting to go. If the thermostatic set point is raised above the actual hearth temperature, the
underfloor burner should activate. It is only possible to program the floor’s thermostatic hearth set point to temperatures
from 200 to 700 degrees F. Once proper temperatures for your application have been established, there should be little
or no need to change the hearth set point.
TURNING OFF THE BURNER
push the
ON/OFF
button on the controller to turn the burner off. The burner will go out and the digital readout on the
controller will go blank.
ALWAYS WAIT 5 MINUTES BEFORE RELIGHTING THE APPLIANCE
NIGHT dOORS:
WARNING:
Never use this appliance as
a space heater to heat or warm up the
room. Doing so may result in carbon
monoxide poisoning and overheating
of the appliance. To avoid an accidental
fire do not use the cooking chamber for
storage space.
