Alignment
Pre-Alignment Procedures
6
6-1
15doc091818
Alignment
SECTION 6 ALIGNMENT
6.1
Pre-Alignment Procedures
Periodically check the sawmill alignment and adjust if necessary. This chapter explains
how to align the entire sawmill. Care should be taken in performing these steps. Sawmill
alignment determines the accuracy and squareness of your cuts.
The sawmill alignment steps are:
1.
Ready the sawmill for alignment
2.
Adjust the blade parallel to the bed rails
3.
Adjust the blade guide arm parallel to the saw head brace
4.
Align blade guides to the blade
5.
Adjust side supports square to the bed
6.
Final Adjustments
To insure accurate alignment, the sawmill frame must be level and a blade properly
installed.
See SECTION 3 Setup & Operation
for setup information.
