Blade Support Installation
WM doc 1/20/21
3-7
3
3.3
Blade Support Installation
Each of the three pre-assembled support arm assemblies attach to the sharpener and
include:
a support tube
a bolt
two nylok nuts
Install the support tubes:
1.
Insert the assembled blade support arm by sliding the bolt into the larger section of the
slot in the support bracket and mount pan, ensuring that one nylok hex nuts is tight
against the support tube, and that the other is below the mount pan.
2.
Slide the support tube away from the sharpener, guiding the bolt into the smaller section
of the slot.
3.
Rest the support arm into the support bracket.
4.
Repeat the steps for each of the other support tubes.See Fig. 3-4.
Each support arm assembly also includes:
FIG. 3-4
TD-BMS25-09
support bracket
nylock nuts
support tube
slot
bolt
