Setup & Operaton
Mode Selection
1
1-19
60AS-R02doc032519
Setup & Operaton
1.2
Mode Selection
See Figure 1-16.
To select an Accuset mode, press the desired Mode Select button
(Auto-Down, Auto-Up or Pattern) located under the display. Press the Manual Mode
Select button to return the control to Manual Mode.
Manual Mode
- This mode allows you to use the up/down function of the sawmill as you
normally would without the Accuset option. The Current Blade Height will continue to be
displayed by the Accuset control.
Auto-Down Mode
- This mode
references the current blade height
and allows you to
choose an increment to move the blade
down
. The Accuset will automatically move the
saw head down and stop at the next increment when you push the drum switch down.
You can store sixteen different increment levels using the four numbered Increment Set-
tings buttons. Each button stores four adjustable increment settings. Push button #1 once
for setting #1. Push button #1 a second time for setting #5, etc...
Auto-Up Mode
- This mode
references the current blade height
and allows you to choose
an increment to move the blade
up
. The Accuset will automatically move the saw head up
and stop at the next increment when you push the drum switch up. Auto-Up mode is pri-
marily used to raise the saw head in large increments when preparing to cut a new log or
log that has been turned. This allows the operator to raise the saw head without having to
hold the drum switch up, freeing the operator to perform other functions while the saw
FIG. 1-16
Mode Select
Up
Down
Toggle
Increment Settings
HOURS:
Manual
Pattern
Manual Mode
|Auto-Down|
Auto-Up |
0:00:34
6 3/4
3H0821
Display
Current Mode
Session Time (hrs:min:sec)
Current Blade Height (inches)
