12
EWSJ Series Outdoor Speed PTZ Dome Camera System User
’s Guide
13
EWSJ Series Outdoor Speed PTZ Dome Camera System User
’s Guide
3.Installtion (Indoor / Wall / Ceiling)
3. 1 Indoor (In-Ceiling)
①
②
③
④
①
②
③
④
①
②
③
④
- The following steps of installation and connection work should be done by qualified service personnel
or system installers and should conform to all local codes.
- Be sure to switch the camera off before installation is completed.
- Do not install the camera near the air outlet of an air conditioner.
- Before installation, set the dome system with Dip switch on the back side of the mechanism part, and
assemble the mechanism and housing according to the below instruction
①
Unpack the dome package and take out the dome drive, dome body (housing), dome cover
(bubble with trim ring) and other components. Insert the dome drive to the dome body and
connect the cables as shown in the above diagram.
②
Assemble the dome cover to the dome body by pressing the cover gently downward to the
dome body with two hands on the side of the cover. Do not press the cover with strong pressure.
This might cause damage to the dome body.Screw the dome cover and body together.
③
Need for additional in-ceiling mount housing, EWSJ-FC. Refer to the page of 2.3 Products sold
separately for the detail. Make a hole in the ceiling to install the camera and prepare for the wire
with connector.For easy installation, screw the three safety screws slightly.
For the safety reason, turn off the main power during the installation.
Connect the wire to the in-ceiling mount housing assembled dome system.
Put the dome system into the ceiling hole.
④
Fasten the safety wire to the ceiling
Do not press the dome cover with too strong pressure while putting the dome system into
the ceiling hole. It can cause serious damage onto the surface of the dome cover bubble
3. 2 Wall Mounting
①
Insert the dome drive to the dome body and connect the cables as shown in the above diagram.
②
Assemble the dome cover to the dome body by pressing the cover gently downward to the
dome body with two hands on the side of the cover. Do not press the cover with strong pressure.
This might cause damage to the dome body.Screw the dome cover and body together.
③
Install the bracket on to the wall to install the camera and prepare for the wire with connector.
For easy installation, screw the three safety screws slightly.For the safety reason, turn off the
main power during the installation. Connect the cable with the assembled dome system.
④
Put the dome system into the bracket. Fasten the 3 installation screws as shown in the above
diagram.
3. 3 Ceiling Mounting
①
Insert the dome drive to the dome body and connect the cables as shown in the above diagram.
②
Assemble the dome cover to the dome body by pressing the cover gently downward to the
dome body with two hands on the side of the cover. Do not press the cover with strong pressure.
This might cause damage to the dome body.Screw the dome cover and body together.
③
Make a hole in the ceiling to install the camera and prepare for the wire with connector.
For easy installation, screw the three safety screws slightly.For the safety reason, turn off the
main power during the installation. Connect the cable with the assembled dome system.
④
Put the dome system into the bracket.
Fasten the 3 installation screws as shown in the above diagram.
