pull the wire on the right hand side to gather up the excess until the heater is secure.
Thread the wire through the remaining small hole to lock the wire and heater in place
(See point 4 - figure 9).
Method C - Securing with the Optional Spacer Frame.
The spacer frame enables the heater to be flat wall fixed. For your safety the frame
and heater must be securely fixed to the rear wall / surround.
Fitting the spacer frame
The rear of the spacer has two screw location slots in the top flange. These should be
to the rear when fitting.
1.
Position the spacer frame against the wall.
Ensure that the spacer frame is central to the
fireplace.
2.
The top rear flange of the spacer frame has
two screw locations. Mark the positions of the
two screw locations on the rear wall (See figure
10).
3.
Remove the spacer frame from the fireplace
and place away from the work area.
4.
Drill the locations using a suitably sized masonry drill bit for the wall plugs supplied.
5.
Insert two wall plugs provided into the holes.
6.
Insert a woodscrew into each hole (See figure
3) and screw in until there is approximately 6mm
of screw protruding from the wall.
Preparing the heater for installation.
1.
Secure the spacer frames to the heater using
four No.8 x 3/8 screws supplied (See figures 11
and 1).
Fitting the heater.
1.
Carefully lift the heater and locate the slots on
the rear of the spacer frame onto the screws in
the wall. The screws can be adjusted to ensure a
tight fit. When mounting to decorative surfaces
such as wallpaper be careful not to drag the
heater down the wall as this may damage the
decorative surface.
Figure 11. Fitting the spacer frame
to the heater
INSTALLER AND OWNER GUIDE
Page 13
©
Baxi Heating U.K. Limited 2010.
Figure 10. Location points
