Wolverine Film2digital MovieMaker, User Manual

Page: 6 / 11

4
DC 12V
TV OUT
Getting Started
1. Attach Power Cord
Plug in the included DC 12V power adapter.
2. Insert SD/SDHC Memory Card (Max. 32 GAB)
Insert the SD/SDHC memory card before power on the MovieMaker device.
..
.
.
Confirm the SD/SDHC card is unlocked (white tab in forward position).
Insert and push the SD/SDHC card inward until it clicks. Improper insertion
may damage the card reader or the SD/SDHC Card, which neither is covered
under warranty.
To dismount/Eject the SD/SDHC card by pushing the card in then release the
card, instead of pulling it out. MovieMaker will power off automatically
when a SD/SDHC card is mounded/dismounted.
Micro SD with an adapter is not compatible with the MovieMaker. The
MovieMaker can only take a SD/SDHC memory card up to 32 GAB max.
3. Turn on/off MovieMaker
Press power button to turn MovieMaker on/off.
4. Clean the Light Table
Push the film door tab left to flip open the door. Use included Blower Brush to
clean the light table very gently.
5. Mount the Reels and Film
1. If your film reel has 8 mm mounting (center) hole, mount the reel directly to
the left shaft, otherwise use the provided reel adapter.
2. Mount the provided 5" reel on to the right shaft.
3. Follow the Film Routing Diagram printed on the face of the machine. Close
the film flap door after the film is properly placed.
8 mm build-in shaft
13 mm Reel Adapter
Insert if needed
Note: If adapters are needed, place
RED color adapter on the LEFT side;
GREY color on the RIGHT side.