-
4.
For best performance
mount the compressor
close to the trumpets
.
The compressor
is not
water resistant, it is important
that it be mounted inside the vehicle in an area that is dry
.
5. The compressor
should be mounted vertically, with its air outlet facing down.
6.
Drill a 5/16 inch mounting
hole. Using the hardware shown in Fig.
3,
secure compressor.
CAUTION:
Plastic tubing between compressor
and trumpets
should not have sharp bends or
kinks which might stop or reduce air flow, resulting in reduced sound output
.
Fig. 4.
7. Electrical
Connections
- Using Vehicle's Factory
Horn Switch
IMPORTANT:
You are not required to use the relay supplied with the kit because the vehicle
f'!~t<:>!y~y~!e;:
.
~~JI:ell
.
<iY
.
!J
.
_
~
.
5Lr~I{lY.
..
.
_
,-
"
-
_
'
_
'
-
-
-
,
.
--
-
-
--
-
'
.
A. For two (2) wire systems: If a vehicle's factory horn has two (2) terminals, simply transfer
the wires to the compressor's
tenninals.
IMPORTANT:
when testing the horns, if compressor motor turns on but the horn does not
sound, reverse the wires connected at the bottom of the compressor.
B. For one (1) wire systems: If a vehicle's factory honi has one (1) terminal simply transfer
wire to the compressor's
positive (+) terminal
.
C
.
Using a I6-gauge wire, the compressors' negative tenninal is connected to any metal body
bolt A ground connection should be free of rust and paint
8. Electrical
Connections
for a New Horn Button Switch:
Install the relay in a dry location with the terminals facing downward near the compressor.
Refer to Figure 5 for wiring
D. Connect
relay terminal 87 to the positive terminal at the bottom of the compressor. Use I 6-
gauge wire or heavier.
E. Connect
relay terminal 85 to the horn switch terminal
.
The other horn switch terminal is
connected
to ground
,
(body of vehicle)
.
An I8-gauge wire is suggested for this connection.
F
.
Connect relay terminals
30/86
to positive (+) 24-volt battery, alternator or accessories. Use
I6-gauge
or heavier wire
.
A 20-ampere fuse should be insalled as shown in Figure 5.
G. Recap
of Terminal
Connections
for New Horn Switch:
Terminals:
30/86:
the two terminals are connected to 24-volt positive (+) using a fuse
.
Tenninal:
8S
is connected to the horn switch. The other terminal of the horn switch is
connected
to ground.
Term
i
nal
:
87 is connected to the positive (+) terminal of the compressor
.
HORN SWITCH
.
(Not Included)
o
+
BATTERY
_
9. It is recommended that you always use the protection covers. They will prevent damage to the
trumpet's diaphragm from rain, bugs, dirt
,
etc. Assemble Horn Protection Covers as shown in
Fig
.
6 below. Do not tighten screws, brackets are placed into position on the front of each trum-
pet and then tighten screws.
If you need help installing your new Wolo horn,
.
our technicians
are available to
answer youi
'
qiiestions;
-
Moriday
'
fliru
"
Priday
;
from
"
9AM
"
'
to
'
4
'
Ii
M
"
EST
"
at
i
~
888-550-4676.
