62
1.
Open the door and press the current programme selection for at least 3 seconds.
2.
Set the new programme.
3.
Close the door.
When you open the door while the appliance is operating, the appliance will stop
operating. The display indicates the code E1. When you close the door again, the
appliance will start operating after 10 seconds.
The 6 control lights indicate the status of the appliance.
a)
One light is on = the relevant programme is running.
b)
One light flashes = Pause - mode.
NOTICE!
If all lights begin to glimmer, the appliance has a malfunction and
cannot be operated any longer. Disconnect the appliance from the mains and
stop the water supply, before you call the aftersales service.
6.3 Subsequent addition of dishes
You can put dishes later in the appliance unless the detergent container has opened.
1.
Open the door slightly to stop operation.
2.
You can open the door completely after the rotating spray arms stopped operation.
3.
Now you can add dishes.
4.
When you close the door, the appliance starts operating after 10 seconds.
6.4 End of a programme
When the display indicates "-" and the acoustic signal sounds 6 times, the programme
has ended.
1.
Switch off the appliance (ON/OFF button).
2.
Turn off the water.
3.
CAUTION!
Wait a few minutes before you open the door as hot damp
may escape.
4.
Wait approx. 15 minutes before you take out the dishes. The dishes are still hot and
will break easily.
5.
It is normal that the appliance is wet inside.
