18
17
Using Your
Citrus Juicer Attachment
Using Your
Citrus Juicer Attachment cont.
1
Place the appliance on a flat, stable, level
surface where it cannot fall.
2
Place the Mixing Bowl on the Motor Housing
with the handle at a 90 degree angle (see
Figure 6). Rotate the Mixing Bowl clockwise
as far as possible until you hear it click into
place (See Figure 7).
3
Place the Accessory Shaft into the mixing
bowl over the center hub
4
Place the assembled citrus juicer
attachment on top of the mixing bowl with
the tab of the citrus juicer strainer slightly to
the right of the bowl handle (See Figure 14).
5
Rotate the citrus juicer strainer until the
tab lines up with the mixing bowl handle
(See Figure 15).
6
Pull the Power Cord out out of the Storage
Cavity at the rear of the Motor Housing.
Ensure that the cord is over the larger
opening in the cord storage area and not in
the locked position, see Figures 10 and 1 1.
7
Insert the plug into the wall outlet and turn
the power switch on the side of the Motor
Housing to the ON position.
If after plugging the cord in, all indicator lights are flashing, the
Mixing Bowl and/or the Lid is not placed correctly on the
Motor Housing. For safety reasons it is not
possible to switch on the appliance in Food Processor Mode both
Bowl and Lid are properly assembled. Check the position
of the Bowl and the Lid and ensure that it matches Figures 7 & 9.
When the Mixing Bowl and the Lid are fitted correctly, only the
Standby Indicator Light flashes. Only then can the appliance be
operated.
8
When processing citrus, we recommend speed I only. Apply steady
pressure over reamer. If juicer is not passing through to bowl turn
motor off and clean pulp from strainer. You can turn the motor off
by pressing the Selected Speed button. Switch the power off by
pressing the power switch, located on the right side of the Motor
Housing and unplug from the wall outlet.
9
When bowl reaches the 3 cup mark turn motor off and pour out
contents
10
To remove strainer rotate citrus juicer housing slightly to the right
(See Figure 14) and lift straight up.
Your electronically-controlled motor comes equipped with an
automatic overload protection system which serves two functions:
1) Time Protection: After two minutes of continuous operation,
the motor will shut off. Fifteen seconds before switching off,
the Standby Indicator Light will begin to flash. This prevents
the motor from overheating during use; and
2) Overload Protection: In the event of an electrical overload,
the motor will automatically shut off. Simply unplug the unit
from the outlet. Wait at least 15 seconds before using again.
Wait at least 15 seconds before using again by pressing the
Speed Button to restart.
Figure 14
Figure 15
HSN_3n1BlenderManual 6/25/10 11:07 AM Page 17
