Wolfen 800 CCBTW Series, Installation Manual

Page: 8 / 12

8
WOLFEN INSTALLATION MANUAL | Wolfen CCBTW Toilet Suites (4*)
INSTALLATION INSTRUCTIONS
WOLFEN INSTALLATION MANUAL
| Installation Instructions
Important Note
The Wolfen back rest should be properly assembled, installed and cared for. Failure to follow the
below instructions may result in serious injury.
The back rest bar meets AS 1428.1-2009 and is manufactured from high quality stainless steel with
a HDPE back rest. It has been tested to a loading of 1100N. Proper care must be taken to install the
grab bar to an appropriate load bearing base, using appropriate fixing bolts.
Installation Instructions:
1. Con fi rm the contents of the box.
The box should contain 1 back
rest grab bar and 6 screws.
2. Assemble the two legs to the stainless panel.
Ensure that the wall the back rest is to be mounted
to contains suf
fi cient timber to provide proper
structural support.
525
3. Using the mounting fl ange plates as a template,
mark the centre of the screw hole locations
and drill in the holes.
Wolfen Back Rest with Fixed Arms
9507171
Installation Instructions
1.
Confirm the contents of the box, The
box should contain 1 back rest and 6
screws.
IMPORTANT INSTALLATION NOTE:
Where there is an inwall cistern installed,
take care to ensure that no screws are
drilled into the concealed cistern.
2.
Assemble the two legs to the stainless panel.
Ensure that the wall the back rest is to be
mounted to contains suffcient timber to provide
proper structural support.
3.
Using the mounting flange plates as a
template, mark the centre of the screw hole
locations and drill the holes.
4.
Install the back rest with the screws provided.
Inspect each screw to ensure it is screwed in
fully
5.
Twist the flanges onto the mounting flange
plates.
Maintenance
Clean product with mild soap and water.
Installation Instructions:
1. Con fi rm the contents of the box.
The box should contain 1 back
rest grab bar and 6 screws.
2. Assemble the two legs to the stainless panel.
Ensure that the wall the back rest is to be mounted
to contains suf
fi cient timber to provide proper
structural support.
525
3. Using the mounting fl ange plates as a template,
mark the centre of the screw hole locations
and drill in the holes.
Installation Instructions:
1. Con fi rm the contents of the box.
The box should contain 1 back
rest grab bar and 6 screws.
2. Assemble the two legs to the stainless panel.
Ensure that the wall the back rest is to be mounted
to contains suf
fi cient timber to provide proper
structural support.
525
3. Using the mounting fl ange plates as a template,
mark the centre of the screw hole locations
and drill in the holes.