5
TM
CLEANING
We recommend the use of soap water or approved cleaners. This product should not be cleaned
with abrasive materials. Damage caused by any improper treatment is not covered by the
product warranty. Refer to Warranty Conditions.
INSTALLATION INSTRUCTIONS
Note: All measurements are taken from finished wall and floor. If fixing to timber framed walls or
partitioning, the wall should be reinforced with noggins to receive fixing bolts/screws.
•
Drill holes into walls at a suitable height into fixing centres and install fixing bolts supplied (fig 1).
•
Fit selected tapware to basin. Fit the selected waste, with overflow if required to basin ensuring it is
sealed with silicone on top.
•
Carefully align basin complete with fittings onto protruding bolts.
•
Insert nylon bushes and locking nut and partially tighten lock nuts to hold basin into position. Make minor
adjusments at this stage to ensure basin is level and then fully tighten lock nuts. Do not over tighten.
•
If desired all visible external edges can be joint sealed using flexible sealant ensuring to wipe off any
excess.
Basin
Locknut
Bolt
Nylon
Wall
Noggin
Section through
basin using wall
fixing bolts
Bush / Washer
(fig 1)
AS1428.1 Installation
Basin dimensions provide acceptable access under basin when fitted to the specified mounting height from
finished floor in AS1428.1.
Position of tapware with extended levers must also be considered when installing this basin to comply with
AS1428.1.
2
X
1
7
3
4
