wolfappliance.com
|
5
SPECIFICATIONS
Gas Supply
Installation must conform with local codes or, in the absence
of local codes, with the National Fuel Gas Code.
Locate the gas supply within the shaded area shown in the
illustration on the following page.
The range is equipped for use with natural or liquid propane
(LP) gas. It is design certified by the Canadian Standards
Association (CSA) for natural or LP gases. The product
rating plate has information on the type of gas that should
be used. For rating plate location, refer to the illustration
below. If this information does not agree with the type of gas
available, check with the local gas supplier. The gas pres-
sure regulator is built into the unit.
GAS REQUIREMENTS
NATURAL GAS
WC
Supply Pressure
5"
(12.5 mb)
Min Line Pressure
7"
(17.5 mb)
Max Regulator Pressure
14"
(34.9 mb)
, .5 psi
(3.5 kPa)
LP GAS
WC
Supply Pressure
10"
(25 mb)
Min Line Pressure
11"
(27.4 mb)
Max Regulator Pressure
14"
(34.9 mb)
, .5 psi
(3.5 kPa)
The range must be connected to a regulated gas supply.
The supply line must be equipped with an approved external
gas shut-off valve located near the range in an accessible
location. Do not block access to the shut-off valve. Refer to
the illustration below.
A gas supply line of
3
/
4
"
(19)
rigid pipe must be provided to
the range. If local codes permit, a certified, 3'
(.9 m)
long,
1
/
2
"
(13)
or
3
/
4
"
(19)
ID flexible metal appliance connector is
recommended to connect the units
1
/
2
" NPT female inlet to
the gas supply line. Pipe joint compounds, suitable for use
with natural or LP gas should be used.
The appliance and its shut-off valve must be disconnected
from the gas supply piping system during any pressure
testing of the system at test pressures in excess of .5 psi
(3.5 kPa)
. The appliance must be isolated from the gas
supply piping system by closing its individual manual shut-
off valve during any pressure testing of the system at test
pressures equal to or less than .5 psi
(3.5 kPa)
.
Wolf natural gas ranges will function up to 8,600'
(2621 m)
in
altitude without adjustment. If the installation exceeds this
elevation, contact an authorized Wolf dealer for a high alti-
tude conversion kit. LP models do not require conversion.
SHUT-OFF VALVE
OPEN POSITION
GAS SUPPLY
TO APPLIANCE
Gas shut-off valve.
Rating plate location.
RATING PLATE
