
wolfappliance.com
|
17
Side Burner Installation
AUXILIARY HARNESS (IF APPLICABLE)
If the Wolf outdoor grill has a serial number prior to the
numbers listed (OG30: 11364339, OG36: 11363946,
OG42: 11363911), an auxiliary harness will be provided
with the side burner. If not, contact Wolf Customer Care at
800-222-7820.
1
The upper rear panel of the grill cart must be removed
to install the auxiliary harness. Remove the rear panel by
removing the four screws.
2
With the provided wire ties, attach the auxiliary harness
to the fire box fin or existing wire harness. The 4-pin
connector cluster should be placed facing the rear of grill
and the 2-pin connector facing the front. The harness
must be tied down tightly and must not touch the grill fire
box. Refer to the illustration below.
3
If connected, disconnect the transformer 4-pin con-
nector at the rear of the grill. Attach one of the 4-pin
connectors to the 4-pin connector attached to the grill.
Attach the other 4-pin connector to the 4-pin connector
from the transformer.
4
Remove the unpopulated connector housing from the
wire harness coming from the grill. Insert each con-
nector housing from the side burner harness to the
corresponding housing on the grill harness and on the
auxiliary harness. There are two connections to be made.
Refer to the illustrations below.
5
Reinstall the upper rear panel of the cart.
INSTALLATION
Auxiliary harness
UNPOPULATED
CONNECTORS
UNPOPULATED
CONNECTORS
AUXILLARY
HARNESS
Connectors
Connector housing