Wolf MW24-1100, Service Manual

Page: 28 / 54

Page 28
Theory of Operation
MW24-1100 MICROWAVE OVEN
3-23
#814888 - Revision A - May, 2009
Demonstration Mode
Demo Mode was incorporated into the software of the
microwave oven to so that the appliance could be used
in a showroom setting, allowing the keys to be pressed
and the display to function, without allowing power to
the microwave cooking components.
To initiate Demo Mode, follow the steps below:
1. Press the TIMER/CLOCK key and “ TO SET -
KITCHEN TIMER - PRESS 1 - TO SET CLOCK -
PRESS 2
” will flash on the digital display (See
Figure 3-71).
2 Though not one of the options given on the display,
Press and release the number 0 key, then press
and hold the QUICK ON/START for three seconds.
The display will flash “
DEMO ON - DURING DEMO
- NO OVEN POWER ” the show a steady “ DEMO “
(See Figure 3-72) . While in Demo Mode, any of the
keys can be pressed and the display will show or
flash the appropriate message. If the QUICK
ON/START key is pressed, the microwave oven will
function in all respects except that microwave cook-
ing components will not be energized and the timer
on the display will abbreviate the count down from
minutes to seconds.
3. To exit Demo Mode, press the TIMER/CLOCK
again and “
TO SET - KITCHEN TIMER -
PRESS 1 - TO SET CLOCK - PRESS 2 ” will
flash on the digital display (See Figure 3-73).
4. Again, though not one of the options given on
the display, Press and release the number 0
key and the display will flash “
TO QUIT DEMO
- PRESS CLEAR ”. (See Figure 3-74)
5. When the STOP/CLEAR key is pressed at this
time, the display will flash “
DEMO OFF ” (See
Figure 3-75) and then show the time of day.
1
2-Hold 3 Sec. c e d 3 Se ld 3 Se d 3 S S
Figure 3-72.
Press Number 0
Key, Press/Hold
QUICK
ON/START Key
Figure 3-71.
Press
TIMER/CLOCK
Key
Figure 3-74.
Press Number 0
Key
Figure 3-73.
Press
TIMER/CLOCK
Key
Figure 3-75.
Press
STOP/CLEAR
Key