wolfappliance.com | 39
MICROWAVE OVENS
Planning Information
DROP-DOWN DOOR MICROWAVE
The drop-down door microwave oven can be installed in a
standard or
fl
ush inset application.
Finish the edges of the opening. They may be visible when
the door is open.
For standard installations, the face trim will overlap stiles
and rails. Refer to the chart below.
For
fl
ush inset installations, a minimum 3 mm reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
BASE SUPPORT
MIN
Drop-Down Door Microwave
57 kg
TRIM OVERLAP
60 cm MODEL
76 cm MODEL
Top
5 mm
5 mm
Bottom
0 mm
0 mm
Sides
18 mm
98 mm
ELECTRICAL REQUIREMENTS
Installation must comply with all applicable electrical codes
and be properly grounded (earthed).
Locate the electrical supply as shown in the illustrations on
the following pages. The receptacle may also be located
in an adjacent cabinet within reach of the power cord. A
separate circuit servicing only this appliance is required. A
ground fault circuit interrupter (GFCI) is not recommended
and may cause interruption of operation.
ELECTRICAL REQUIREMENTS
Electrical Supply
220-240 V AC, 50/60 Hz
Service
1600 W
Receptacle
grounding-type (earthed)
Power Cord
1.2 m
