wolfappliance.com
|
7
INSTALLATION
wolfappliance.com
|
7
5
Slide the upper chimney flue onto the support frame and
attach to the support frame using screws provided. Refer
to the illustration below. Slide the lower chimney flue
over the upper and temporarily secure in this position
using adhesive tape.
6
Raise the hood to the support frame and connect the
hood to the support frame with four screws provided.
Refer to the illustration below.
7
Insert the two prong connector from the hood into the
receptacle on the support frame.
8
For internal blowers, install the blower. For remote
blowers, continue to step 9.
9
Make wiring connections. Refer to page 9.
10
Once wiring connections are complete, remove the
adhesive tape securing the lower chimney flue, then
lower until it rests on the hood.
WARNING
Failure to install the screws or fixing device in accor-
dance with these instructions may result in electrical
hazards.
Installation
ISLAND HOOD
1
Mark the center line for location of four mounting holes
using dimensions shown in the illustration below. Use
the template provided to mark the mounting support
locations, then use a 1
1
/
4
" drill bit to create a hole for the
electrical power supply.
2
Place four mounting screws into the ceiling, then posi-
tion the support frame on those screws. Once the sup-
port frame is in place, tighten screws.
3
Determine the desired height of the support frame and
adjust the height by removing four screws. Once the
desired height is achieved, reinstall and tighten screws.
4
Place the damper on the support frame then attach
ducting to the damper.
8
5/8
"
(219)
ELECTRICAL
LOCATION
11"
(279)
Mounting location.
Support frame.
MOUNTING
SCREW
UPPER
FLUE
MOUNTING
SCREW
Install telescopic flue.
Mount hood.
