10
I N S T A L L A T I O N
C H E C K L I S T
•
All internal packaging has been
removed.
•
All shipping restraints have been
removed from the burners.
Radiants are oriented properly
over grill burners with triangle
cutout towards back (see below
illustration).
•
Specified clearances to any
combustible materials have been
maintained.
Batteries are installed to push
button ignitors properly
All burners light properly,
individually and with adjacent
burners lit.
All flames appear normal.
The drip tray slides freely. The
grease collection tray is properly
placed.
The pressure regulator is connect-
ed, and set for 5"(127) WC for
natural gas or 11"(279) for LP gas.
The LP cylinder is in an upright
position and the hose is not
kinked.
The unit has been tested and is
free of leaks.
The user has been informed of the
gas supply shut off valve location.
I
N S T A L L A T I O N
Leak Testing Procedure:
•
Check that all the control knobs are
in the OFF position.
•
Mix a half soap and half water solu-
tion.
•
Turn cylinder valve knob counter-
clockwise one turn to open.
•
Apply soap /water solution on joints
of the gas delivery system.
•
Blowing bubbles in the soap solu-
tion indicates that a leak is present.
•
Stop a leak by tightening the loose
joint or by replacing the faulty part
with a replacement part recommend-
ed by the manufacturer.
Do not
attempt to repair the cylinder valve if
it should become damaged. The
cylinder must be replaced.
•
If you are unable to stop a leak,
shut off the gas supply at the cylinder
valve. Remove the cylinder from the
grill. Call an authorized gas appliance
servicer or LP gas dealer.
Do not
use the appliance until the leak is
corrected.
•
Push in and turn any control knob
to the on position to release pressure
in the hose and manifold.
•
Turn OFF the control knob.
L E A K T E S T I N G
Perform a leak test each time the gas
cylinder is connected to the regula-
tor, and any time part of the gas sys-
tem is disconnected or replaced. This
applies to natural gas as well as LP
gas. Perform a leak test at least once
each year whether the LP gas supply
cylinder has been disconnected or
not.
Test for leaks at the cylinder valve,
cylinder welds, regulator (especially
attached to cylinder valves), hose and
connections.
NO SMOKING! Do not
use or permit
sources of ignition in the area while
doing a leak test.
Conduct leak tests outdoors in a well
ventilated area.
Do not
use a flame, such as a lighted
match to test for leaks. Use only a
soap /water solution for leak testing.
(Example: half liquid soap and half
water.)
Have a dealer check the cylinder for
deterioration when the tank is filled
in accordance with regulations.
Immediately replace cylinder if any
deterioration is found.
Testing for gas leakage of the
appliance shall be conducted
according to the manufac-
turer’s instructions.
Do not store a spare LP gas
cylinder under or near this
appliance.
Never fill the cylinder more
than 80% full.
If this information is NOT fol-
lowed exactly, a fire causing
death or serious injury may
occur.
Dimensions in parentheses are in millimeters unless noted.
Radiant positioning
gas bbq grills install 803861 rev-b 3-04.qxp 3/23/2004 9:01 AM Page 10
