infomation.
12. Setting Up User’s Code
Press holding the key
【
Code
】
for 3 sec., key in 4-digit user’s code when figure
bar cursor twinkling on panel screen. The code will be transmitted to alarm
center to identify the users. If your system has not connected with the center
yet, it is no necessary for you to set up user code.
13. System Initialization
Press the key
【
program
】
on the panel under the disarming status, then press
【▲】
and
【↓】
to twinkle typeface “ Other Setup” , press
【#】
to confirm , press
【▲】
and
【↓】
to make “system initialization” twinkle, pressing
【#】
to
comfirm entering system initialization status. All the set will be recovered to
original status.( Those code of P.I.R , door magnet, remote controller,
intelligent remote control switch will lose and must be renwed code)
System Usage
1.
Arm/ Disarm
¾
Keyboard Arming/ Disarming
Key in 4-digit password on keyboard under disarming status, press the key
【Out】
going to away disarming status, press the key
【Home】
going to stay
disarming status. Key in 4-digit password on keyboard under arming or alarm
status, press
【*】
to disarm. Current status will display on the screen at the
same time.
Notice: All the defence zones will take effect under
【
Out
】
status , the mode is
suitable for nobody-in. Part of the defence zones take effect under
【
Home
】
status , the mode is suitable for anybody-in.
¾
Remote Controller Arming/ Disarming
Press the key
【
Lock
】
on the remote controller, the system will enter away
disarming status about 20-60 sec. delay later. By use the key
【
Lock
】
together with
【
Urgency
】
on the remote controller, you can arm at once
.
Main panel will send off indicating tone to denote that phone line are not
ready. Press the key
【
Unlock
】
on the remote controller to disarm.
2.
Panic Alarm
Press the middle key
【
Urgency
】
on the remote controller or on the panel , the
system will alarm at once and dial automatically whether it is in arming status
or not.
3.
Dealing With Alarm
The system will make horn hoot for 5 minutes to frighten intruder, while it also
dials the saved phone numbers automatically. Hosts will hear the saved alarm
message when they pick up the telephone. Press the
【*】
to enter 2 minutes of
spot monitoring status, press
【#】
to confirm receiving alarm. The main panel will
stop dial and close horn. The system will arm again. If one number can’t be put