Troubleshooting
EN
26
Warranty
The warranty conditions of our local company or
importer apply in all countries. Under the terms of
the warranty we will repair faults on your device
free of charge, insofar as material or manufactur-
ing defects are the cause. To make a claim under
warranty please contact your seller or your nearest
branch.
CE Declaration of Conformity
Further details about the device are con-
tained on the separately enclosed CE
Declaration of Conformity, which forms part
of this instruction manual.
Environmentally-friendly disposal
Power tools, accessories and packaging must be
disposed of via an environmentally compatible recy-
cling chain.
Power packs/batteries:
Do not dispose of power packs in domes-
tic waste, by burning or throwing into
water. Power packs must be collected,
recycled or disposed of in an environmen-
tally-friendly manner.
Power tool (without power packs/
batteries):
Do not throw your power tool away with
domestic waste! Take it to a disposal
facility.
Troubleshooting
WARNING!
Risk of injuries or material damage
¾
In case of doubt always take your device to a specialist workshop.
¾
Before any inspection or any work on the device, switch off the motor and remove the operating
arm.
Problem
Possible cause
Remedy
The device switch-
es off.
The power pack is too hot.
Allow the power pack to cool.
The power pack is discharged.
Charge the power pack.
The temperature of the device (electronics) is too
high.
Allow the device to cool and if necessary,
clean the ventilation slots
Overcurrent release
If this occurs again take your device to a
specialist workshop.
The device will not
switch on.
The power pack is discharged.
Charge the power pack.
Overcurrent release
If this occurs again take your device to a
specialist workshop.
Power pack temperature too high or too low.
Allow the power pack to cool down or
heat up.
The power pack is defective.
Arrange for the power pack in the oper-
ating arm to be checked by a specialist
workshop.
The cutting blade
becomes hot.
The cutting blade is blunt.
Consult a specialist workshop.
There is a lot of friction because of a lack of
lubrication.
Oil the cutting blade.
Uneven running,
severe vibration of
the hedge trimmer.
The cutting blade is damaged.
Consult a specialist workshop.
The cutting blade fastening has come loose.
Consult a specialist workshop.
Summary of Contents for HT 40 eM
