Wolf Garten 10534047, Manual

Page: 27 / 198

Troubleshooting
EN
27
Troubleshooting
WARNING!
Risk of injuries or material damage
¾
In case of doubt always consult a specialist workshop.
¾
Before any inspection or any work on the device, switch off the motor and remove the operating
arm.
Problem Possible cause Remedy
The device switch -
es off.
The power pack is too hot. Allow the power pack to cool.
The power pack is discharged. Charge the power pack.
The temperature of the device (electron -
ics) is too high.
Allow the device to cool.
Overcurrent release
If this occurs again take your device to a special -
ist workshop.
The device will not
switch on.
The power pack is discharged. Charge the power pack.
Overcurrent release
If this occurs again take your device to a special -
ist workshop.
Power pack temperature too high or too
low.
Allow the power pack to cool down or heat up.
The power pack is defective. Visit a service centre.
Inadequate cut
Blade is blunt Visit a service centre.
Blade worn Visit a service centre.
Warranty
The warranty conditions of our local company or
importer apply in all countries. Under the terms of
the warranty we will repair faults on your device
free of charge, insofar as material or manufactur -
ing defects are the cause. To make a claim under
warranty please contact your seller or your nearest
branch.
CE Declaration of Conformity
Further details about the device are con-
tained on the separately enclosed CE
Declaration of Conformity, which forms part
of this instruction manual.
Environmentally-friendly disposal
Power tools, accessories and packaging must be
disposed of via an environmentally compatible recy -
cling chain.
Power packs/batteries:
Do not dispose of power packs in domes -
tic waste, by burning or throwing into
water. Power packs must be collected,
recycled or disposed of in an environmen -
tally friendly manner.
Power tools (without power packs/
batteries):
Do not throw your old power tool away
with the domestic waste. Take it to a
disposal facility.