Settings
65
EN
10 Settings
•
To access the Settings mode, press and
hold the SET key for 2 seconds when the
device is powered on.
•
In the Settings mode, press the arrow key to
move from one parameter to the next (P10,
P20 etc.).
•
Press the Enter key when the parameter is
selected to access the different options
(P22, P23 etc.).
•
Use the arrow keys to select the desired
settings.
•
To exit the Settings mode and return to the
Measuring mode without saving the settings
press the ESC key.
Seven different parameters are available in the Settings mode:
NOTE!
If a setting applies solely to a special probe, then the corresponding parameter will only
be displayed when that probe is connected to the device.
Parameters
pH
EC
O2
Default setting
P10
Delete all data (CLr)
x
x
x
No
P20
Test pH probe
x
100 %
P30
Review calibration values
x
146.6 µS/cm,
1413 µS/cm
12.88 mS/cm,
51.5 mS/cm
P40
Review cell constant
x
1.00
P50
Setting for conversion factor
Cond. >TDS
x
0.5
P60
Applies only to O
2
probe
(not in scope of supply)
x
Fast
P70
Setting the temperature unit
x
x
°C
