Data recording
27
If you wish to stop recording earlier than
planned, press the START/STOP button on
the data logger.
The measurement values are then shown in the
display. The data logger continues to record data.
REC is shown in the display.
To abort the recording, press and hold the
START/STOP button for 2 seconds.
To
switch
off
the
data logger, press the
START/STOP switch again.
4.3 Starting
recording
by
pressing the device
button
Fig. 18: Software settings before begin-
ning to operate the device by pressing
the device button
Perform the steps described in chapter 4.1.
Select
Start logging > Button
.
Set
the
logging rate.
Click
Save
.
You can now disconnect the data logger from the
PC and position the device anywhere you wish.
To begin recording, press the START button
on the data logger.
The start display is shown for 3 seconds, see Abb.
2. The temperatures measured by the internal
temperature sensor and the external temperature
probe as well as the relative humidity are then
shown alternately. The recorded data are saved in
the memory of the data logger.
To stop the recordings, press the STOP but-
ton again.
NOTE!
To start recording data again at the click of a
mouse, you must first activate the function Start
logging > Button again in the indoor climate
software, see Abb. 8.
