Page 136
Adding a Non-3G Card I/O Module
To add a new 3G card, position the monitor with the rear panel facing you and
follow the instructions below.
1.
Place the monitor on a solid, static-free surface and remove the power
cord(s).
2.
Using a small Phillips screwdriver, remove the top cover.
3.
Remove the blank cover plate from the rear panel for the new I/O module’s
slot.
4.
Remove the new I/O module from its shipping container being careful to
remain grounded.
5.
Insert the new I/O module in the empty slot until the I/O module snaps in
securely.
6.
Attach the rear panel connectors to the card and screw it to the rear panel
frame.
7.
Replace the lid and the screws.
WARNING!
Do not attempt to operate the monitor without all rear panel
cover plates in place. Doing so will compromise the unit’s ability
to shield contain unwanted radio emissions.
Important
:
Keep the blank cover plate for future use. We recommend taping
it to the side of the monitor; but do not cover the air vent.
WARNING!
Do not attempt to operate the monitor without all rear panel
cover plates in place. Doing so will compromise the unit’s
ability to shield contain unwanted radio emissions.
