Page 125
Adding a Redundant Power Supply
The AMP2-16V Series monitors come with a single 150W power supply that is
sufficient to drive a fully-loaded monitor. However, an additional power supply (also
150W) is available as an option to provide for system redundancy. Power supply
modules are to be installed into their specialized slots on the far left and far right of
the back panel. When adding an optional redundant power supply, remove the
blank cover to gain access to the power supply slot.
Precautions
Before unpacking your new power supply, make sure you have a static- free surface
on which to work.
Requirements
1.
A small Phillips screwdriver
2.
The redundant power supply option kit
Adding the AC Power Supply
To install an additional power supply, position the monitor with the rear panel
facing you and follow the instructions below.
1.
Remove the power cord.
2.
Using a small Phillips screwdriver, remove the blank cover plate on the rear
panel on the far right-hand side.
3.
Slide the power supply into the slot from the rear panel, making sure that the
power supply’s connector seats securely into the connector inside the
monitor.
4.
Replace the screws that hold the power supply in place.
5.
Attach the power cords to the power supply connectors and plug them into
outlets protected by different breakers.
Important
:
Keep the blank cover plate for future use. We recommend taping
it to the side of the monitor; but do not cover the air vent.
Important
:
It is crucial that the secondary power supply be plugged into an
outlet on a different circuit breaker than the original power supply
to ensure system redundancy.
