FLOOR LAMP
1.
Procedure for making the connection between the lamp and the remote control:
Switch off the lamp at the power switch for at least 10 seconds, then switch it on again.
Press the
button briefly within 3 seconds after switching on.
The lamp flashes 3 times to confirm that the connection has been established successfully.
2.
Procedure for resetting the settings and re-establishing the connection:
Switch off the lamp at the power switch for at least 10 seconds, then switch it on again.
Press the
button quickly 5 times within 3 seconds after switching on.
The lamp flashes 6 times to confirm that the settings have been reset.
3.
Switching on and off
The lamp is switched on by briefly pressing the
button. The brightness of the last settings remains
unchanged.
4.
Press the
button. This allows you to switch between the individual light segments of the lamp:
- upper light ring only
- the two light columns only
- the upper light ring and the two light columns
The change takes place in a cycle.
5.
Press the
button to switch on the lower light ring.
Press the
button to switch on the two light columns.
6.
A long press on the
button increases the brightness.
A long press on the
button reduces the brightness.
7.
If the lamp is without power for more than 10 seconds, e.g. by switching it off at the power switch or in
case of a power failure, it will switch on again with the brightness and light settings last set when the
power returns.
GB
07/20
Artikel/Serie Nr.: 3226.02.xx.9600
Wortmann & Filz GmbH . Im Langel 6 . D-59872 Meschede
WOFI LEUCHTEN
+49/(0)2903-449 449 +49/(0)2903 - 449 459 [email protected] www.wofi.de
