10
Setting the current time
After the power plug has been connected to a socket, „
12:00
“ will be
indicated on the display.
Press the
Prog
button. „
CLOCK
“ appears on the display. While the
Prog
,
h
and
min
buttons are illuminated, you can set the current time
by pressing the
h
and
min
buttons. The clock will begin to run as soon
as the buttons are no longer illuminated. Confirmation is not required.
Note
: After a power failure or after the power plug has been discon-
nected, the time must be reset.
Programming the Auto-On time
The Auto-On system of the appliance automatically starts the brewing
process at the set time. The Auto-On time can be programmed up to
24 hours in advance.
Press the
Prog
button twice. „
TIMER
“ appears on the display. While
the
Prog
,
h
and
min
buttons are illuminated, you can change the timer
setting by pressing the
h
and
min
buttons. The new Auto-ON time is
programmed as soon as the buttons are no longer illuminated.
You can check the Auto-On time any time by pushing the
Prog
button
twice..
Note
: After a power failure or after the power plug has been discon-
nected, the Auto-On time must be reset.
Brewing coffee
You can remove the water reservoir for filling purposes. Fill only cold
water into the reservoir. The water level indicator shows the quantity
of fresh water required to brew the desired number of cups à 125 ml
coffee.
To fill in coffee powder, open the front cover. Fold a paper filter size
1 x 4 along the fold lines and place it into the filter. The paper filter
is not allowed to stick out beyond the rim of the filter and must
therefore be pressed slightly into place by hand.
Fill in the required quantity of coffee powder. Depending on your
personal taste, use approximately 5 to 7 grams of
medium
ground
coffee per cup. If the coffee powder is ground too finely, the filter may
overflow.
Aroma function
You can activate the aroma function to brew stronger, aromatic coffee.
We recommend this function especially for brewing smaller quantities
of coffee. Press the
Aroma
button to activate the function. The
Aroma
button will light up until completion of the brewing process and
„
Aroma
“ appears on the display.
Please note that the brewing time is slightly extended.
Auto-On function
If you wish brewing to start up automatically at a programmed Auto-
ON time, press the
Auto
button. The button will light up and „
AUTO
“
appears on the display.
The brewing process will start up automatically at the programmed
AUTO-ON time. The
Auto
button is then no longer illuminated, the
