26
Coffee
Coffee soft pads
You can use all standard coffee soft pads with an external diameter of 7 cm (cof-
fee quantity approx. 7 g). Coffee pads with a smaller diameter do not produce the
best tasting coffee. Hard pads which are offered for espresso machines and pads
with additives for cappuccino, or similar, must not be used.
Never put damaged pads, loose coffee powder or instant coffee into the pad
cartridge (9) as it would clog and block the adjusting knob (10) so that the pad
cartridge (9) can no longer be removed. Should this nevertheless happen once,
please read the instructions in the section “Troubleshooting.”
The amount of coffee powder in a pad is optimally adjusted to a 125 ml cup. The
following fi ll amounts are pre-confi gured when delivered to the customer:
Start button
(3)
approx. 125 ml ideal for 1 pad
Start button
(5) approx. 250 ml ideal for 2 pads
You can vary the fi lling quantity per cup as per your personal needs, allowing
you to vary the strength of the coffee. Read the section “Programming mode” for
more.
Pad cartridge
Turn the adjusting knob (10) to the position
and then right back to the
home position . As a result, the pad cartridge (9) will be pushed out of the
brewing chamber somewhat to facilitate removal.
The pad cartridge (9) can be used from two sides. The side marked with
is for a
coffee pad and the side marked with
is for two coffee pads.
The more carefully you insert the coffee pads, the better the coffee will taste. It is
therefore important to adhere to the following instructions:
▪ Evenly distribute the powder in the coffee pad up to the rim before insertion.
▪
Using one coffee pad
:
After insertion, lightly pat the coffee pad with your fi ngertips so that a small
depression is created in the middle. Ensure that the paper edge of the coffee
pad is lying fl at in the depression of the pad cartridge (9) and does not stick
out or fold inwards.
▪
Using two coffee pads:
Press the lower coffee pad fi rmly into the recess of the pad cartridge (9). The
paper edge will point upward here. Then insert the second coffee pad accord-
ing to the procedure described above for one coffee pad.
▪ When inserting the pad cartridge (9), ensure that the pad is not displaced, as
otherwise the seal will not close properly.
▪ Turn the adjusting knob (10) as far to the right as possible in the range .
Preparation
1. Place one cup in the middle or two cups next to each other on the grate insert
(1) (see figure).
You can use cups with a height of up to 10 cm.
2. Wait until the On / Off button (4) illuminates white.
3. Depending on whether you have prepared one or two cups, press the cor-
responding start button
(3) or
(5). The On / Off button (4) illuminates
white during preparation.
