When using the ‘return to home’ function, your quadcopter must be at least 20 meters away. Hold the ‘return to home’ button on
your transmitter for 2 seconds. Your quadcopter will automatically return in its opposite direction and will descend. Be aware this
quadcopter does not have a GPS, so it will not know the original position it took off and save this position as its ‘home’.
When using this function the quadcopter will return in the opposite direction and slowly descends to the ground. So, watch out
when the quadcopter is flying really low or high, it might fly over your head or descend to quickly. NEVER use this function when
trees, water or any other obstacles are nearby your quadcopter can crash into.
One key to return
The first flight
1. For your first flight make sure to be with a person experienced in flying copters. We advise you to make your first flights on a
relatively soft surface to protect the copter.
2. Find a location away from people, with a smooth surface and without obstacles. Trees, electric lines and water points in the
immediate vicinity should be avoided!
3. Place your copter on the ground about 10 feet away from you. Mind that, when you have a quadcopter, the coloured blades
indicate the front of the copter. It is easiest to position yourself behind the copter for an easier control.
4. Turn the copter on first. Then turn on the remote controll (for some models this will be the other way around). Some models
require arming of the motors first. Turn on the copter as well as the controller. then move trottle up and down to connect. after this
move throttle to the left low corner and the directional lever to the right lower corner at the same time, hold these down for a few
seconds, this will arm the motors.
5. Start the engine and take off to about 1 meter from the ground. In this way you avoid the phenomenon called "ground effect".
Near the ground the air currents behave differently than at a higher altitude and this will prevent you from losing control of the
copter.
6. Then try to fly gently in one direction. If the engine flies away in the wrong direction, make a controlled landing and try again.
If the copter is unstable, resulting in frenetic flying in all directions, and rotates around its axis so that you have to constantly
correct its flight, then the gyroscope is probably not calibrated properly. To perform recalibration, connect the drone to the
transmitter (part Activation in the manual), then click on 100% button of the remote and move both sticks to the bottom left. When
the calibration is performed, you will either hear a long beep or see flashing lights (on the PCB) or both.
Note: The calibration is done in the factory, it is usually not necessary to do it when you receive the product.
- When finished flying, always turn off the copter first, then the remote control.
- Always fly in an open and Jellyfished environment to avoid dangerous situations.
- Remember to disconnect the battery of the copter after each flight.
- If you lose control of the copter, disable the propulsion of the engines immediately by pushing the throttle lever down to turn it off.
Engines are brushed and eventually wear out. When worn out they need to be replaced. For more informations go to
www.wltoys.eu.
Never go full speed for the first 3 flights. After 3 flights, blow out engines with air when possible.
Spare engines can be bought on www.wltoys.eu or with your reseller.
- Ensure that you adhere to all the legal requirements that exist for your copter model in the country in which you are using it.
- Always use a fully charged battery.
Calibration
- Always stay out of reach of rotors.
- Ensure that the copter in flight is always within sight and under control.
CAUTION
- Do not use the copter when it has visible or mechanical damage.
Copyright WLtoys.eu | DroneX BV
