A serial to Ethernet test can also be performed by using the hyper terminal.
In the same way, input any character in the screen of terminal program for network, and check if
same character is displayed in the screen for serial (Ethernet to Serial)
※
The above test can also be performed in a program called, “Device Terminal program”, which is easy
and simple to use.
Device Terminal Program
Device Terminal is a program which integrates both serial and network communications into one user
interface so that you can test your WIZnet gateway module easily.
As shown in above Figure, the upper part of the program allows you to configure your serial setting of
WIZ610Wi. By clicking the “Open” button, serial communication is enabled.
The lower part of the program allows you to configure the network settings. You can test both TCP Client
and TCP Server modes at the same time. If the Server Mode is enabled, Device Terminal will operate as
server mode, and the WIZ610Wi module will work as client mode. The PC where the Device Terminal is
operating will work as a server, the IP address of the PC should be set as Server IP of the module. If
Server mode is not checked, Device Terminal will operate as client mode, and the module as server. For
the IP address and port, please input your IP address and port number of WIZ610Wi and click the
“Connect” button to start a network communication.
메모
[q7]:
Very vague
instruction….
메모
[q8]:
I think this is
stating the obvious
Summary of Contents for WIZ610wi
Page 2: ...C CL LI IC CK K...
