© Carl Wittkopp GmbH - Errors and omissions excepted
Rel. 1.1
12.07.2017
Quick start no. 600-0007-00-0
FinKey (VdS Class 2 with additional relay) -
Quick start
1 Notes on safety
• After programming the user finger, the electronic lock should be opened and locked several times.
• After each locking doublecheck if the safe is closed.
1.1 Notes on safety emergency lock
• Due to security reasons it is recommended not to leave the key unattended in the lock.
• Don’t store the key in the safe.
• The keys have to be stored at a safe place and may only be accessible by authorised persons.
• When losing the key exchange the lock immediately.
• Make sure after each locking if the safe is locked.
Detailed installation/operating instructions are available for download on our website carl-wittkopp.com.
2 Programming of master fingers
The same finger (recommendation) or three different ones can be programmed as master finger.
1. Red, green and blue LED flashes permanently.
2. Pull the 1st
master finger
over the sensor.
3. Wait until the green and red LED flashes.
4. After 3 sec. pull the 2nd
master finger
over the sensor.
5. Wait until the green and red LED flashes.
6. After 3 sec. pull the 3rd
master finger
over the sensor.
7. Wait until the green LED flashes.
4 Opening / locking
1. Blue LED flashes permanently.
2. Pull the
user finger
over the sensor.
3. Turn the handle within 3 seconds into "opening" / "locking" position.
3 Programming of user fingers
The master finger should not be the user finger.
1. Blue LED flashes permanently.
2. Pull the
master finger
over the sensor.
3. Press the button
*
E
on the remote contol.
4. Enter your user-ID which has to be programmed (between 1 and 100).
5. Press the button
*
R1
or
*
R2
on the remote contol.
6. Press the button
*
OK
on the remote contol.
7. Pull the
user finger
several times over the sensor.
8. Wait until the green and red LED flashes simultaneously.