Anchor 4000
Installer manual
Installation and commissioning instructions
en_A4000-Teil 2-Errichterhandbuch V2.03.docx
2 / 7
General
Locks of the Anchor 4000 series have
standard installation dimensions and can
be mounted in all 4 installation positions
(right, left, top, bottom). They have been
designed for a boltwork with two blocking
edges, i.e. for the force to be applied only
on only the flank of the bolt.
They are intended to be installed in safes
made of metal.
The
electronic
lock
requires
no
maintenance in a normal residential or
office environment. We recommend a
security and function test of the electronic
lock after around 10,000 closings.
For security reasons it is not permissible to
install the electronic lock in the area of the
cutouts in the safe door.
It is essential that the lock is protected
against
attacks
from
outside.
We
recommend that you protect against access
the security-relevant parts of the high-
security lock also when the door of the
container that holds the valuables is open.
It is not permissible to use two locks of the
same type in connection with analog
keypads
without
any
additional
components for locking state detection.
Do not apply any lubricants or other
substances to the lock.
Always use the following sequence for installation:
•Check the preconditions for installation
•Wiring / installation of the cables
•Set up the power supply
•Function test of the locking mechanism
•Make all the settings (user system, Dualcode, inputs and outputs, delay time)
Ensure that the load limits are not exceeded at any time.
You can find the corresponding values in Annex C "Technical data".
