Pneumatic System
69
Auxiliary Controls (optional)
Auxiliary controls, if installed on your unit, are located outside, directly behind the cab on the street
side (see Figure 6
6). For these controls to be enabled, the operator must press the Auxiliary Controls
switch on the control panel (see Figure 6
7).
Auxiliary controls include a dual handle joystick (see Figure 6
6) to operate both the forks and the
arms and a packer control station to operate the packer (see Figure 6
6). A throttle advance switch
(or speed-up) is also provided to speed up the packing process and the raising/lowering of the arms
6).
Figure 6
-
6 Auxiliary controls
Figure 6
-
7 Auxiliary control switch
Speed-Up Switch (optional)
Located on the in-cab control panel, this switch (see Figure 6
8) engages/disengages the optional
speed-up feature which is used to increase the engine speed up to 1500 RPM whenever a pack or an
auto-pack cycle is initiated.
When the speed-up feature is activated, either ON or AUTO, the corresponding part of the switch
turns green.
Forks
lever
Arms
lever
Down
Up
Packer
controls
Throttle
Advance
Forks
lever
Arms
lever
Down
Up
Packer
controls
Speed-
up
Summary of Contents for FEATHERWEIGHT
