8
Packer
Maintenance
The W
ITTKE
™ packing system has a heavy duty
guiding system using special hardened steel wear
plates. Because of the frequent use of the packer,
Labrie Enviroquip Group recommends the operator to
perform daily inspections and the maintenance
personnel to perform weekly inspections.
Greasing all moving parts on a daily basis is very
important. The proper adjustment of the proximity
switches is also very important (refer to
on page 48 and
Replacing Packer Wear
Plates
If the packer has a vertical movement greater than 3/
16 inch or a side movement greater than 1/8 inch,
verify the packer wear plates and body guides.
Different types of steel are used:
Hardox 500 (bottom of the body)
Hardox 450 (packer)
Chromium overlay wear strips (on packer shoes
and channels) – Optional
3/8” Chromium overlay wear strips on hopper
bottom rails, 3/8” Hardox 500 on hopper side rails
and 3/8” Hardox 450 on packer sides – Optional
package
To replace the packer wear plates:
1.
Remove the packer (see
page 131).
2.
Remove the wear plates from the packer by cutting
the welds (see Figure 8
1).
Danger!
Always lock out and tag out the vehicle
when inspecting or performing
maintenance on it (see
Summary of Contents for FEATHERWEIGHT
