Assembly
V.. / NV.. / CV..
en-14
2022-D059517
Revision: 05
5.2
Mounting the motor to the gearbox
Only
the “self-contained version” gearbox
variant with a drive shaft [O] is
not
intended for
motor mounting. It is possible to drive the
gearbox directly via the drive shaft, e.g. by
means of a belt pulley.
For all gearboxes
with
motor-mounting, the
following information applies:
Observe the specifications and safety instructions of the motor
manufacturer.
Observe the safety and processing instructions for the threadlocker to be
used.
Valid only for corrosion resistant gearboxes and gearboxes in
Hygienic Design:
Align the geometry of the seal surfaces before mounting the motor.
For
corrosion resistant
gearboxes, use sealing adhesives
(e. g. Loctite
®
573) to avoid leaks.
Place an appropriate sealing ring between adapter plate and motor for
gearboxes in
Hygienic Design
to avoid leaks.
In addition,
WITTENSTEIN alpha GmbH
offers a suitable sealing plate.
The tightening torque value [TA] of the clamping bolt
[H] can be found on the clamping hub [C].
The value for the tightening torque can also be
found in Chapter 9.1 "Specifications for mounting
to a motor".
O
XX Nm
H
C
TA
C
