premo
Assembly
Revision: 02
4022-D045530
en-17
5.2.3 Mounting premo XP line with slotted holes on a machine (optional)
For adjusting the gearing backlash between output pinion and toothed rack / counter-wheel,
premo XP line
features slotted holes and guides on the sides as an option. An additional
adjustment device is no longer necessary. The ground side surfaces can also be used as a torque
support.
Center the servo actuator by the ground side
surfaces in the sled.
Adjust gearing backlash between output pinion and
toothed rack / counter-wheel.
For the proper setting of the gearing backlash,
you will find further information in the "alpha
rack & pinion system" manual.
Use only the washers included with the delivery for
fastening the gearbox to the machine (see
Table "Tbl-5").
Slide the washers onto the fastening screws.
Smear threadlocker (e.g. Loctite 243) onto the
fastening screws.
Fasten the servo actuator to the machine with the
fastening screws through the slotted holes (A).
Mount the servo actuator in such a way that the
name plate remains legible.
For appropriate screw sizes and tightening
torques, see Chapter 9.1 "Specifications for
mounting on a machine", Table "Tbl-13".
Optionally, you can fixate the servo actuator to
the machine additionally with cylinder pins.
Further information can be found in section
"Pinning the mounted and aligned servo
actuator (optional)".
Size of premo XP
line
Size 1
Size 2
Size 3
Outer diameter
[mm]
–
14
16
Clamping length
[mm]
–
5
6
Tbl-5: Dimensions of the washers
A
