Witt WS955, User Manual

Page: 78 / 84

~ 78 ~
If the hood doesn’t work properly when opening or closing the extractable
unit, push “TIMER” key six times consecutively in order to reset parameters.
Working mode:
The first time the system is switched on, hold down the light key to set the
hood with the remote control.
If two cookerhoods-radiocontrol systems are installed in the same room or in
the immediate vicinity, each system may affect the operation of the other,
due to the fact that they have the same code. Therefore it will be necessary
to change the code of one of the radio controls.
Warning: The battery should be replaced every year to guarantee the
optimal range of the transmitter.
To replace the exhausted battery, take the plastic lid off, remove the battery
and replace it with a new one, observing the correct battery polarities. Used
batteries should be discarded in special collection bins.
The appliance has an electronic device to switch it off automatically four
hours after the last operation carried out.
Generating a new transmission code. The radio control is supplied with
preset factory codes.
If you want to create a new set of codes, proceed as follows: press and hold
the UP, STOP and DOWN buttons simultaneously for 2 seconds. After the
LEDS light up, press the UP and DOWN buttons within 5 seconds. The LEDS
will flash 3 times to indicate that the process is completed.
Warning: This procedure deletes all previously stored codes.
Learning the new transmission code:
After changing the transmission code on the radio control, the cooker hood
electronic control unit must be made to set the new code as follows: Press
the emergency button twice consecutively to cut off power to the appliance
and reset it; from this moment, there are 15 seconds to press the light key so
that the hood synchronizes itself with the new code.