30
CONFIGURATION PROCEDURE
The table must be configured. Please implement the following steps:
I
) Important! Before you start, make sure there is no more pot on the hob
II) Disconnect the appliance from the grid by removing the fuse or turning the circuit breaker off
III) Reconnect the table to the grid
IV) Procedure:
* Take a pot with a ferromagnetic bottom with a minimum diameter of 16 cm
* start the procedure within 2 minutes after reconnecting the hob to the grid
* don’t use the [ O/I ] touch
V) First step: cancel the existing configuration
1) Press the touch n°2 and hold down
2) The symbol [ ] will appear on each display
3) With your other hand, press successively and
quickly (less than 2s) on each [ ] display.
Begin from the front right side and turn contrary
clockwise, as described on the picture (a -> b -> c -> d)).
A double "beep" means an error occurred. If so, start again from item 1).
4) Remove your fingers from the touch control, then push again on touch 1 during few se-
conds, until blinking [ E ] symbols appear.
5) Wait until [ E ] symbols stop blinking.
6) After few seconds, [ E ] are automatically transformed in [ C ].
The existing setup has been cancelled.
VI) Second step: new setup
1) Take a pot with a ferromagnetic bottom with a minimum diameter of 16 cm2
2) Select a cooking zone by pushing on the corresponding [ C ] display
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected cooking zone is now
configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6)
All the cooking zones are configured once all the displays are turned off.
Note: Please use the same pot for the whole procedure.
Note: Never put several pots together on the zones during the setup-process.
WHAT TO DO IN CASE OF A PROBLEM
The symbol [ E4] appears :
Reconfigure the table
If the symbol remains, please contact the After sales service
a
d
c
b
Summary of Contents for 6424300
Page 32: ...18053 0 ...
