5.5 Zooming in and out of the diagram
In order to better recognise irregularities in the diagram, the zoom
function can be used to increase the size of the diagram by up to
16 times. The larger the zoom factor (between 1x and 16x), the
greater the distance between the lines of the diagram.
Requirement: The diagram display mode is selected.
1.
Press the
“Zoom in”
touch button.
ð
A selection list is shown.
Fig. 21: Changing the size of the diagram
2.
Select the desired zoom factor.
ð
The selected zoom factor is highlighted green.
5.6 Changing the display mode
The Watch Expert provides two different display modes. Both show
the most current measured rate deviation, amplitude and beat error
(repère). The display modes differ in the following ways:
n
In the diagram display mode, the rate deviation and beat error
(repère) are measured and shown in the form of a diagram
(
).
n
In the VARIO display mode, rate stability and amplitude are
measured over a longer time period. At the same time, the
smallest, largest and resulting mean values are shown
(
).
To switch between diagram and VARIO display modes, proceed as
follows:
Touch the main display.
ð
The display mode is changed. The desired display is
shown.
Setting measuring parameters
Changing the display mode
27.02.2018
Precision measuring device Watch ...
44
