WARNINGS & SAFETY INSTRUCTIONS
Do not operate WiTi unless you have read and understood this manual and WiTi
is installed as per the instructions.
•
Ensure the cable used to install
WiTi
Anti-Theft is of adequate thickness to provide the
necessary current for the circuit.
•
WiTi
Anti-Theft must be installed away from environmental conditions that may cause
damage to the units circuitry including water, salt spray and humidity.
•
WiTi
Anti-Theft is connected to the internal house battery of the camper or trailer, insufficient
charge of the house battery will affect the performance of the Anti-Theft and Break Away
functions. The condition of the battery in the camper
or trailer must be maintained and
checked and the battery must have sufficient charge before towing.
•
NOTE : When servicing the electric brakes or magnets it is recommended that
WiTi is disconnected to prevent accidental short circuits.
WiTi ANTI-THEFT SYSTEM
WiTi
detects movement via a highly sensitive gyroscope and accelerometer. In the event
an attempt is made to gain access to or move the camper o r trailer the Anti-Theft system will
be activated. All the lights flash, the alarm sounds and the brakes are applied making it
practically impossible to tow the camper o r trailer.
This continues as long as movement is
detected and if there is no movement
W
iTi
Anti-Theft will reset after 30 seconds. The brakes
are applied for 5 seconds and then released if there is no movement to prevent the battery
from discharging unnecessarily.
To activate the Anti-Theft, press and hold the button on the remote control for 1/2 a second, the
side and front markers and indicators will flash once followed by a 3 second safety pause and
then a dou b l e flash to indicate the system is armed. The Alarm Status LED will illuminate. To
deactivate, press and hold the button on the remote control for 1/2 a second and the lights will
flash once and the Alarm Status LED will switch off.
WiTi
incorporates an advanced safety system to ensure the system cannot be accidentally
activated whilst the camper or trailer is being towed. After activating the system, if
movement is detected during the 3 second safety pause the system will not arm. The lights will
not flash twice and the Alarm Status LED will not illuminate. The system must be deactivated
again by pressing the remote control button for 1/2 a second before another activation
sequence is attempted.
WiTi BREAK AWAY
WiTi
Anti-Theft includes a Break Away system that activates the brakes in the camper or trailer
in the event the tow vehicle and trailer are separated.
Installation of the Break Away is optional
and should not be connected to an existing break away system.
Connect a Break Away switch
(not supplied) as per the wiring instructions. In the event the switch is pulled out then the brakes
will activate and the stop lights will illuminate. The Break Away function will remain active until
the pin is re-inserted into the switch. The condition of the battery in the camper or trailer must
be maintained and checked and the battery must have sufficient charge before towing.
WiTi GPS TRACKING
WiTi
features an optional GPS Tracker. If supplied, connect the GPS Tracker to the corresponding
plugs on the wiring loom. Refer to page 6 for activation and operating instructions.
Summary of Contents for Anti-Theft System
Page 1: ......
