
www.witeg.de
witeg Labortechnik GmbH, WB Precise Water Bath
14
Check the power supply cord before you stick it into the electrical outlet.
Do not use power bars to extend the power supply cord.
Only use extension cables with sufficient cable cross section.
Do not touch the device with wet hands during the usage because this might cause an
electrical shock.
If unexpected sound, smell or smog is generated by the device, pull out the main plug and
contact the manufacturer or your supplier immediately.
Disconnect the power supply plug before cleaning or maintenance.
If you use radiation or contaminated samples the responsibility is only up to you.
Do not put heat-sensitive items on the device.
Warn all attendees if you leave the device unattended.
Pay attention when you lift up the lid, hot condensation water may drop down or hot steam
could come out.
Do not clean the scorching device.
Reparations and amendments should only made by
witeg
authorized people.
Contraventions exclude the warranty.
Make sure, that the safety switch is adjusted up to 20-30°C over max. temperature.
Oth
erwise the heating maybe doesn’t work.
Use this device only if you read the whole safety instructions.
This device should only used by persons who are familiarized with safety instructions made
for laboratories.
Pay attention that no liquid reaches the controller or inward of the capsule.
You have to keep the device clean if you want to get a longer life of it.
Wear corresponding protective work clothing during the usage.
Pull out the power cable if you didn’t want to use the device for a longer time.
Make sure that the device can not slip away.
The device could get damaged if the vibrations are to strong.
To avoid heat congestions or fires make sure that there is enough space for air circulations.
Avoid direct solar radiation.
Do not use the device near highly combustible materials.
Do not set the device outdoors.
It is superiorly to set the device in a good illuminated place to avoid accidents engendered
by handling errors.