02
3
.
Size
4
.
Installation
90
OK
90
OK
90
OK
90
OK
01
.
Installation
02
.
Installation chart
1. Please use the material offered by our company to install and fix the product in the suitable place.
2. Please make the product's mechanical position fit to the wind cup parallel the level surface, just as the installation drawing,
otherwise, it will affect the testing of the wind speed.
Note: To make the system operate normally, please remember that the controller must be installed near the place where the
awning can be protected, and the place can reflects the surrounding's light intensity and wind speed. Please ensure that there
is no other same frequency (433.92MHz) device to work constantly; otherwise, the system will be interfered.
03
1) Switch on the power and
then the motor will vibrate.
220V Power
1
5
.
Code learning
1
2) S
button one time.
hort press the learning
3) The motor will vibrate. The
code learning is successful.
6
.
Set Wind Threshold
1)
seconds and the left numbers on
the LCD would flash.
Long press the left button for 2
2)
numbers will circulate from 0 to 5
Short press the left button and the
numbers stop flashing and the wind grade is set.
Chart 1-1 Wind Threshold Corresponding to Actual Wind Speed
1
2
3
4
5
0
Wind Threshold
Wind speed
Close wind speed test
10km h
/
15km h
/
20km h
/
30km h
/
>40km h
/
7
.
Set Light Threshold
1)
seconds and the right numbers on
the LCD would flash.
Long press the right button for 2
2)
the numbers will circulate from 0 to 5.
Short press the right button and
the left button one time to exit the setting. The
Chart 1-1 Light Threshold Corresponding to Actual Light Intensity
1
2
3
4
0
Light Threshold
6
7
8
9
5
Actual Light Intensity
Close light
intensity test
2000Lux
5000Lux
10000Lux
20000Lux
Actual Light Intensity
40000Lux
60000Lux
70000Lux
80000Lux
90000Lux
1
1
Long press for 2 seconds
1
right button one time to exit the setting. The
3)Select the figure you want and then press the
numbers stop flashing and the light intensity is set.
3)Select the figure you want and then press
Long press for 2 seconds
Light Threshold