01
Wind-Light Sensor Instruction
2
.
Structure
Learning button
Wind adjust button
Wind threshold
Base
Solar panel
Wind cup
Fixing components
Screw
1
.
Technical Data
Power: Solar Panel + Rechargeable
(3.7V,180mAh)
Protection Index: IP44
Temperature: -20
℃
to +60
℃
Lithium Battery
Working Current: 12mA
Codes: Rolling Codes
Frequency: 433.92MHz
≤
Light adjust button
Light
threshold
RS 001 Instruction
04
8
.
Testing mode
1
、
Wind speed testing mode
1) Short press the left button four times.
3)
come out from wind speed testing mode.
Short press the right button once, it will
When the sensor is in wind speed real-time testing mode, the figures reflect current wind speed outside. For example, the figure “1.0” represents real wind speed is 10km/h outside.
2) the dot in the middle is always on.
2
Light intensity testing mode
、
3)
come out from light intensity testing mode.
Short press the left button once, it will
2)
of the LCD is always on.
the dot at the the right corner
1)Short press the right button four times.
When the sensor is in light real-time testing mode, the figures reflect current light intensity outside. For example, the figure “10.” represents real light intensity is 10000Lux outside.
Note: In light intensity testing mode, the numerical value displays the light intensity from 1000 to 100000lx. It shows“00.” below 1000lx, and “99”above
9
.
Function
If the wind speed exceeds the set grade for 6 seconds
continuously, an Up order is given to the motor and the
awning will close automatically.
As long as real wind speed is higher than the set
grade, you cann't open the awning by any means
(manual control, emitter control and light sensor are invalid).
1
The strong wind protection function
、
2
The light sensor function
、
0 0
0 0
4
4
1
1
detects real-time wind speed and control awning to close automatically if the wind exceeds set limit. It is powered by solar
panel . It is environmental-friendly.It can work continuously more than a year after fully charged.
The sensor is wireless emitter which controls awning to open or close according to the change of light intensity. Also, it
100000lx. For example, the figure “12.” represents 12000lx. It will return to initial interface 3 minutes later if there is no further operation is done to the sensor.
If the wind speed falls below the set grade for 30
seconds continuously, the sensor sends signals
to the motor and activates the control by emitter
and light sensor.
If the light intensity exceeds the set grade for
10 minutes continuously, a Down order is given
to the motor and the awning opens automatically
If the light intensity below the set grade for
10 minutes continuously, an Up order is given
to the awning and the awning closes automatically.
User manual
Model:WSRS001
Brand:WISTAR